This is a follow up video for adding streaming audio via WiFi to the Android based BLUEDUO remote display for the Elad FDM-DUO.This is accomplished by using the Soundwire audio streaming Android app. You must also install the Soundwire server application on a PC or Raspberry Pi. The audio stream from the FDM-DUO can be accessed via the TX USB connection. It is not necessary to run the FDM-SW2 for the streaming audio nor for the use of the BLUEDUO Android app. Doing so will confuse the BLUEDUO app running on your Android device. Once this is setup you can then use the BLUEDUO app and the Soundwire app to listen to and control the FDM-DUO from a remote location in your home as long as the location is in range of your bluetooth and wifi signal.The paid version of Soundwire will give you additional options for tweaking or reducing latency depending of your particular WiFi setup for best performance. However, increasing latency for better streaming performance may make the BLUEDUO’s scope appear a little behind the spectrum / waterfall. It’s best to try to reduce the latency to it’s lowest level while maintaining good streaming audio quality.